Open-source USB tool unlocks Nvidia's half-speed GPU AI limiter on Windows — lifts GPU's FP16 math performance up to 65%, UEFI unlocker covers RTX 20, 30, and 40-series desktops and laptops
Reported by Tom's Hardware1 source ↓
An open-source UEFI tool, nv-uefi-unlocker, lifts Nvidia’s tensor rate cap on RTX 20, 30, and 40-series GPUs under Windows.
Key points
- The unlock runs before the Nvidia driver loads, without a VBIOS flash or patched driver
- It must be applied again after each boot and does not persist through power loss
- UEFI mode is required; Secure Boot must be off or configured to trust a self-signed EFI
- Compatibility varies by model, and some cards in supported series remain untested or have known issues
- Laptop GPUs need to be powered on when the unlock runs
Details
Tom’s Hardware reports that nv-uefi-unlocker runs from a FAT32 USB drive in a firmware stage before the operating system loads Nvidia’s driver. The project uses a community payload to change GPU speed-selector registers; its download contains scripts and self-built binaries, not Nvidia firmware. A script downloads public Nvidia driver packages and rebuilds the firmware files locally.
The unlock is temporary and must be run again at each boot. The system must start in UEFI mode, with Secure Boot disabled or set to trust a self-signed EFI; the project says it cannot bypass games’ Secure Boot requirements. The tool’s developer reported higher FP16 performance on a laptop RTX 4060, while other results in the article came from card owners and varied by test.
The project lists RTX 30-series cards as fully compatible and RTX 40-series desktop and laptop cards as fully compatible; RTX 20-series support is listed as compatible with known model-specific issues. The article notes that support listings do not mean every card has been tested. For laptops, the discrete GPU must be powered when the tool runs.
Written from coverage as of
Stocks in this story
Change since open: 20 Nov to 21 Nov 2026
Last refresh